Chapter 2. Bios Setup; Introduction - Albatron PX845EV1 Series User Manual

Chapter 2. BIOS Setup

Introduction

This section describes PHOENIX-AWARD™ BIOS Setup program which resides in the
ROM BIOS firmware. The Setup program allows users to modify the basic system
configuration. The configuration information is then saved to CMOS RAM where the data is
sustained by battery after power-down.
The BIOS provides critical low-level support for standard devices such as disk drives, serial
ports and parallel ports. As well, the BIOS controls the first stage of the boot process,
loading and executing the operating system.
The PHOENIX-AWARD
version of an industry standard BIOS. This means that it supports the BIOS of Intel® based
processors.
This version of the PHOENIX-AWARD
and password protection as well as special configurations for fine-tuning the system chipset.
The defaults for the BIOS values contained in this document may vary slightly with the
version installed in your system.
Plug and Play Support
This PHOENIX-AWARD™ BIOS supports the Plug and Play Version 1.0A specification as
well as ESCD (Extended System Configuration Data) write.
EPA Green PC Support
This PHOENIX-AWARD™ BIOS supports Version 1.03 of the EPA Green PC
specification.
APM Support
This PHOENIX-AWARD™ BIOS supports Version 1.1 & 1.2 of the Advanced Power
Management (APM) specification. These features include system sleep and suspend modes
in addition to hard disk and monitor sleep modes. Power management features are
implemented using the System Management Interrupt (SMI).
PCI Bus Support
This PHOENIX-AWARD™ BIOS also supports Version 2.1 of the Intel PCI (Peripheral
Component Interconnect) local bus specification.
TM
BIOS installed in your computer system's ROM is a custom
TM
BIOS includes additional features such as virus
25
PX845EV1/ PX845EV1 PRO