To Change The Increment Or Decrement Setting; Using The Pre-Defined Increment/Decrement Keys; Specifying An Increment Value; To Change The Increment Value - HP 8921A User Manual

To Change the Increment or Decrement Setting

Using the Pre-Defined Increment/Decrement Keys

The INCR and INCR
factor of 10.
For example; if the
Tune Freq
the knob or push of the down-arrow or up-arrow keys, pushing INCR
changes the increment value to 100 MHz.

Specifying An Increment Value

The INCR SET key is used to assign a specific increment value. The increment
value may use different units than the field you are incrementing/decrementing.
For instance; if the RF Generator
could increment in units of dB or mV.

To change the increment value;

1. Move the cursor to the numeric entry field to be changed.
2. Press INCR SET, and enter the desired value and unit-of-measure using the DATA
keys.
3. Use the down-arrow and up-arrow keys or CURSOR CONTROL knob to change the
field's value by the increment value you set.
Example of Setting an Increment Value
This example changes the
1. Access the TX TEST screen and position the cursor in front of the Tune Freq field.
2. Press 1 0 0 MHz to set the frequency at 100 MHz.
3. Press INCR SET 1 5 MHz.
4. Turn the Cursor Control knob. The field's value changes by 15 MHz for each knob
click.
keys change the increment/decrement value by a
presently changes by 10 MHz for every click of
setting is displayed in dB V, you
Amplitude
in increments of 15 MHz.
Tune Freq
Chapter 3, Operating Overview
Entering and Changing Numbers
once
65