Table of Contents
Advertisement
Chapter 16, Radio Interface Screen
Using the Radio Interface (Manual Operation)
Using Interrupts
414
There are two interrupt lines that, when armed, allow monitoring of interrupt
conditions. An interrupt is tripped when a logic low, determined by the same
Logic Voltage as described in
, is detected. When tripped, the field directly below
409
from
to
Armed
Tripped
interrupt, then select
Arm
Besides displaying the word
of the Test Set's status registers. This makes it possible to generate SRQ interrupts
or query a condition register to find out if an interrupt has occurred. Refer to
"Using The Radio Interface (Remote Operation)" on page 415
"Setting the Radio Interface's Logic Level" on page
. To re-arm the next interrupt you must first disable the
.
, an interrupt condition will set a bit in one
Tripped
will change
Arm/Disable
.
Advertisement
Table of Contents
