Table of Contents
Advertisement
Chapter 6, Call Processing Subsystem
Using the CALL DATA Screen
To View The Reverse Channel Words From a Mobile Station Origination
NOTE:
If a word is chosen which was not part of the decoded reverse channel's message stream, all
the fields will be blank when it is displayed.
160
1. If not already done, condition the Test Set.
Processing" on page 130
2. If not already done, configure the Test Set.
for further information.
3. Connect the mobile station to the Test Set as shown in
bile Station to the Test Set," on page
4. Turn on the mobile station.
5. Ensure that the Test Set is in the Connect state.
page 133
for information on how to bring a mobile station up on a voice channel.
6. Select the Active field. The Active annunciator will light when the control channel
is turned on.
7. Dial the desired phone number on the mobile station and press the SEND key on the
mobile station's handset. The mobile station signals the Test Set on the reverse control
channel with an origination message which includes the dialed phone number, the mo-
bile station's MIN number and the mobile station's ESN. If the mobile station transmit-
ted properly on the reverse control channel, the message RECC Return will flash
momentarily in the upper right-hand corner of the CALL CONTROL screen. The Test
Set will then reconfigure itself to the voice channel assignments set up in the Voice
Channel Assignment section of the CALL CONTROL screen. The Access an-
nunciator will then light while the Test Set signals the mobile station on the assigned
voice channel. The Connect annunciator will light if the mobile station properly sig-
nals the Test Set on the reverse voice channel. The mobile station is now connected to
the Test Set on the assigned voice channel.
8. Select the Display Word field. A list of reverse channel words which can be dis-
played will be presented. Position the cursor on the desired word and select it. The de-
coded contents for each of the fields in the selected word will be displayed in the lower
portion of the display.
See "CALL DATA Screen Message Field Descriptions" on page 144
tion of each of the available reverse channel words.
Step 7. and Step 8. in the above procedure can be reversed, that is, the desired
word can be selected first, then a mobile station origination can performed. If the
origination is successful, the contents of each display word contained in the
reverse control channel's message stream will be updated when the decoding is
complete.
The origination does not have to happen while you are viewing the CALL DATA
screen.When the CALL DATA screen is viewed, the contents of the display
words will contain the decoded data from the last successful call processing
function (registration, origination, page, release, order).
See "Conditioning the Test Set for Call
for further information.
See "Configure the Test Set" on page 131
115.
See "Page a Mobile Station" on
Figure 14, "Connecting a Mo-
for a descrip-
Advertisement
Table of Contents
