Table of Contents
Advertisement
Chapter 10, Signaling Encoder (AF Generator 2)
DTMF Sequence Encoder
Pre-Emp
Send
Send Mode
Standard
Stop
Symbol Frequencies (Hz)
326
This field determines whether the encoder's signal passes through or bypasses
the 750 ms pre-emphasis network. Pre-emphasis may be required when testing
some FM receivers.
See Also
Twist field description, on page 327
Selecting this field causes the DTMF sequence to be output.
This field selects the format used when
•
Single outputs the entire sequence once.
•
Burst outputs the sequence the number of times specified in the Bursts field.
•
Cont causes the sequence to be output continuously until Stop is selected.
•
Step allows you to output the tones in a sequence one at a time by pressing Send for
each tone.
This field selects the DTMF standard used for your radio.
Selecting this field stops the sequence being output.
The eight column/row frequencies are automatically entered by the
field setting. You can change the frequency values using the DATA keys.
is selected to output a sequence.
Send
Standard
Advertisement
Table of Contents
