Page A Mobile Station - HP 8921A User Manual

Page a Mobile Station

Using the CALL CONTROL Screen to Test Call Processing Functions
There are two methods that can be used to page a mobile station:
• Page a mobile station that has registered with the Test Set.
• Page a mobile station that has not registered with the Test Set.
Paging a Mobile Station that has Registered with the Test Set
1. Ensure that the Test Set is in the active state.
Channel" on page 132
2. Connect the mobile station to the Test Set as shown in
bile Station to the Test Set," on page
3. Turn on the mobile station.
4. If the CALL CONTROL screen is not displayed, select CALL CNTL from the To
Screen menu. The CALL CONTROL screen will be displayed.
5. Position the cursor on the Display field and select Data.
6. Ensure that the mobile station has registered with the Test Set.
Station" on page 132
7. Select the Page field. The Page annunciator will light while the Test Set pages the
mobile on the forward control channel. If the mobile station responds properly on the
reverse control channel, the message RECC Return will flash momentarily in the up-
per right-hand corner of the CALL CONTROL screen. The Access annunciator will
then light while the Test Set sends the mobile station an alert order on the assigned
voice channel. The mobile station should ring.
8. Press the SEND key on the mobile station. The Connect annunciator will light if the
mobile station properly signals the Test Set when the SEND key is pressed. The mobile
station is now connected to the Test Set on the assigned voice channel. The voice chan-
nel assignment section will be updated: that is, any "-" in the left-hand fields will be
replaced with appropriate information.
See "Turn On The Test Set's Control
for information on how to activate the Test Set.
115.
for information on how to register the mobile station.
Chapter 6, Call Processing Subsystem
Figure 14, "Connecting a Mo-
See "Register a Mobile
133