Message Contents that can be Modified Using the CALL BIT screen
[] Access
Active
The contents of eleven different messages can be modified from this screen. The
message to be modified is selected using the
messages whose contents can be modified are:
•
Forward Control Channel Messages for Paging, Origination, Order Confirmation, and
Orders.
•
SPC WORD1 - System Parameter Overhead Message Word 1
•
SPC WORD2 - System Parameter Overhead Message Word 2
•
ACCESS - Access Type Parameters Global Action Message
•
REG INC - Registration Increment Global Action Message
•
REG ID - Registration ID Message
•
C-FILMESS - Control-Filler Message
•
MS WORD1 - FCC mobile station control message Word 1- Abbreviated Address
Word
•
MS IntVCh - FCC mobile station control message Word 2- Extended Address-
Word - Voice Channel Assignment
•
MSMessOrd - FCC mobile station control message Word 2- Extended Address
Word - Order
•
FVC V Mes - FVC Mobile Station Control Voice Channel Assignment Message
•
FVC O Mes - FVC Mobile Station Control Order Message
When lit, the
Access
mobile station with command information on the forward voice channel. This is a
transitory state.
The Test Set's speaker is turned off when in the access state. This is done to
eliminate any possible audio feedback which may occur if the mobile station's
microphone is open.
This field is used to turn on the forward control channel of the Test Set or to force
a return to the active state from any other state (register, page, access, connect). If
the forward control channel of the Test Set is already active, selecting this field
will deactivate and then reactivate the control channel.
annunciator indicates that the Test Set is signaling the
Chapter 6, Call Processing Subsystem
CALL BIT Screen
field. The eleven
Set Message
163