Agilent Technologies B1500A Self-Paced Training Manual page 102

To Use Auto Analysis Function
The auto analysis capability allows you to display/move the marker/line on the data graph
automatically after measurement. The above example is the Vth gmMax test definition.
To add the auto analysis operation to your test definition, open your test definition and do the
procedure shown above (1 to 5). The Auto Analysis component can be added to your definition.
Interpolation Mode
Check this box to enable the interpolation mode. You can position marker between measurement
points.
Line 1, Line 2
This area sets the line 1 or line 2 automatically displayed and moved to the specified position
after the measurement.
Check Enable box to enable the line.
For Type, select a line type, Normal, Gradient, Tangent, or Regression.
For Axis, select the axis effective for the line.
In First Point and Second Point, specify the cursor points used to draw line.
In Gradient, specify the slope of the Gradient line.
Interpolation
Line 1 setup
Line 2 setup
Marker setup
4-23