Final_xxxx.exe
• Arguments:
-a GPIB_address
-l log_file_name
Example:
–a GPIB0::5::INSTR –l C:\temp\prb.log
• Response:
none
Start
Chuck down
End
Stop condition
To specify the final procedure on the Repeat Measurement Setup dialog box, enter the full path
name of Final_xxxx.exe into the Final Procedure field.
The procedure is called after one of the stop condition is detected. This procedure sets wafer
chuck to the DOWN position.
Note:
To ignore the Arguments, set the GPIB address and log file name in the prober_info.ini.
C:\Program Files\Agilent\B1500\EasyEXPERT\Utilities
C:\Program Files\Agilent\B1500\EasyEXPERT\Utilities
C:\Program Files\Agilent\B1500\EasyEXPERT\Utilities
5
7-16