FS Functions
•
TC REGEN
When the FS-4Pro HD powers up in
•
Reads the timecode of the last track recorded.
•
Adds 1 to the number.
•
Stores the new timecode as the number that will be
assigned to the first frame of the next recording session.
If the drive is empty, i.e. no existing recordings, the
FS-4Pro HD uses the
TC SET and UB SET Can Be Set at the Same Time
Both parameters, TC SET and UB SET, may be set and are not mutually
exclusive as in some groups, i.e. LCDLIGHT.
TC SET
FS-4Pro HD only
The Timecode Set parameter stores a user defined timecode in
the FS-4Pro HD's non-volatile memory. This value is available
for use by the FS-4Pro HD immediately after exiting
•
TC FREE RUN
The FS-4Pro HD uses this value on the next recording
after it is set in
•
TC REGEN
This is the starting value when using an empty hard
disk drive for recording.
•
TC REC RUN
This is the value used to begin every recording session
after a power cycle.
68
FS-4Pro HD only
TC SET
TC SET
00 : 00 : 00 : 00
HH : MM : SS : FF
FS-4Pro HD only
.
TC SET
FS-4Pro HD only
FS-4 HD and FS-4Pro HD Portable DTE Recorders
TC REGEN
value.
BACK
mode, it:
.
TC SET