Notifying Users By Email About Status And Activity - Adaptec Snap Server 700i Series User Manual

Notifying Users By Email About Status and Activity

Controller LEDs
The controller has two LEDs that indicate status.
Fault LED (yellow)
These LEDs operate as described in the following table:
LED Condition
Master On
Fault On 5-10 seconds only
On continuously
Notifying Users By Email About Status and Activity
You can set up Adaptec Storage Manager to send email messages (or notifications) to
a selected email address when an event, such as the creation of a pool or the failure
of a disk drive, occurs on the iSCSI Storage Appliance. Email notifications also help
you monitor these activities on your IP SAN from any location:
• Progress of scheduled jobs, such as snapshot creation
• Changes in the status of the physical components of your IP SAN, such as disk drives
• Changes to the iSCSI Storage Appliance, such as the expansion of a volume, the
creation of a mirrored volume, or the creation of a hot spare
Only the email address you specify receives email notifications (see page 122). You
can specify which types of events generate email messages to ensure that urgent
issues receive immediate attention.
Follow the instructions in this section to:
• Set up email notifications (see page 121).
• Send a test email (see page 122).
• Modify a recipient's information or remove a recipient (see page 122).
• Modify email settings (see page 123).
• Disable email notifications (see page 123).
120 Snap Server 700i Series User's Guide
Master LED (green)
HOST
FAULT !
SEP MASTER
Indication
Controller is current Master for enclosure.
Enclosure is powering on.
Fault condition exists on controller
EXP