Adaptec Snap Server 700i Series User Manual page 128

Notifying Users By Email About Status and Activity
Sending a Test Message
To ensure that an email recipient is receiving event notifications, you can send them
a test message.
To send a test message:
In the Enterprise View, select the Management Service you want.
1
Click the
Configure
2
Notifications
Select the email address.
3
In the
Actions
4
The test message is sent. If the test is successful, the email recipient receives the
test message. If the test fails:
Ensure that the recipient's email address is correct.
a
Ensure that your SMTP server address is correct.
b
Try sending the test message again.
c
Modifying a Recipient's Information or Removing a Recipient
This section describes how to modify a recipient's email address, change the types
of event notifications that are sent, or stop sending email notifications.
To modify a recipient's information:
In the Enterprise View, select the Management Service you want.
1
Click the
Configure
2
Notifications
Select the email address.
3
Modify the recipient's information as required, then click
4
Or,
In the tool bar, click
Modifications become effective immediately. If you have deleted an email recipient
but you still want to be notified about status and activity by email, set up a new
email recipient following the steps in "Setting Up Email Notifications" on page 121.
122 Snap Server 700i Series User's Guide
button, select the Management Service, then select
.
menu, select
Send test message
button, select the Management Service, then select
.
Delete email recipient
.
.
OK
, then click to confirm the deletion.
Yes
Email
Email