Adaptec Snap Server 700i Series User Manual page 186

Using the Wizard to Configure Your iSCSI Storage Appliance
The CLI Setup wizard then prompts you to enter the values you prepared in
"Before You Begin" on page 34.
Adaptec highly recommends that you record the values you enter during
Note
this task and store them for future reference.
At the Hostname prompt, type a name for the iSCSI Storage Appliance, then
2
press
Enter
Type the network domain to which the iSCSI Storage Appliance belongs, then
3
press
Enter
Press
Enter
4
Use this format:
Press
Enter
5
. Use this format:
Enter
Type (the whole word, not just "
yes
6
then press
password, then press
Type a new operator password, then press
7
then press
Press
Enter
8
Press
Enter
9
to which packets for destinations that do not have routes defined for them in the
system should be sent), then press
Press
Enter
10
supported), then press
Type the IP address for the iSCSI Storage Appliance, then press
11
Use this format:
Type the netmask of the iSCSI Storage Appliance, then press
12
Use this format:
Type the IP address to be used for broadcasts, then press
13
Use this format:
When the configuration is complete, the host name given to the iSCSI Storage
14
Appliance displays (for example, myhostname#).
Type , then press
quit
15
Disconnect from the iSCSI Storage Appliance.
16
To avoid permanent data loss, do not modify the default BIOS settings of
Caution
the RAID controller. To safely configure or modify the iSCSI Storage Appliance, use
either the CLI or Adaptec Storage Manager only.
180 Snap Server 700i Series User's Guide
. Use alphanumeric characters, such as
. Use alphanumeric characters, such as
to accept the current system date, or type a new date, then press
[hh:mm:ss@mm/dd/yy]
to accept the current time zone, or type a new time zone, then press
GMT+12 – GMT-12
. Type the new password, then press
Enter
.
Enter
.
Enter
to accept the DHCP default setting (No).
, or type a default gateway address (the name or IP number of a router
, or type the IP addresses of your DNS servers (up to three are
.
Enter
xxx.yyy.zzz.aaa
xxx.yyy.zzz.aaa
xxx.yyy.zzz.aaa
to log out of the CLI.
Enter
Hostname
Domain
") to create a new administrative password,
y
Enter
. Confirm the new password,
Enter
.
Enter
or .
Hostname1
or .
Domain1
Enter
Confirm the new
.
Enter
.
Enter
.
Enter
.