Adaptec Snap Server 700i Series User Manual page 173

Click the plus sign, then
8
type in the IP address of
the target portal.
Leaving the iSCSI Name
9
field blank will force
discovery of all available
targets. Or you can
double-click the iSCSI
Name field and type in
an iSCSI name of a
target. Then click
and
Target Settings
provide the password
when asked to connect
to the target(s).
The Target Settings tab shown above offers several options:
Notes
• Click the
Auto-bind discovered Targets
bound to the Initiator port
• Click to put a check in the
even after the adapter is reset or the server is rebooted.
• Click to put a check in the
enabled targets when
• A check will automatically appear in the
and the target will be saved into the flash memory.
For example, to log off some targets but retain their information, uncheck the
box next to these targets, and then click
Enable Target
want to remove a target, uncheck the
.
Settings
When a dialog to refresh target status displays, click
10
target status. The QLogic Initiator, by default, will try to log onto all targets
simultaneously.
Save
box. The Initiator will access the bound targets
Bind
Enable Target
or
Refresh Save Settings
Bind
iSCSI Configuration for Microsoft Windows
button. All discovered targets will be
box. The Initiator will log on to
is clicked.
box once Discovery is run
Dynamic
Save Settings
box next to it, and then click
to see the updated
Yes
Appendix A Configuring iSCSI Initiators
Click
. Or, if you
Save
167