System Boot - Intergraph InterServe 80 SL System Setup

System Boot

ERROR - Does not boot from the expected boot device.
Reason
Operating system not on the system drive.
BIOS attempts to boot from the wrong hard
disk drive.
IDE hard disk drive is connected to IDE
controller.
ERROR - Series of beeps and error messages display.
Message
Refresh Failure
Parity Error
Base 64 KB Memory Error
Timer Not Operational
Processor Error
8042 - Gate A20 Failure
Processor Exception Interrupt
Solution
Install the operating system as described in
Chapter 7.
Ensure the SCSI adapter for the system
drive is installed physically lower in the slot
order than all other SCSI adapters. For
more information, see Chapter 5.
BIOS cannot boot from a SCSI hard disk
drive if IDE hard disk drive is connected.
Disconnect all IDE hard disk drives. For
more information, see Chapter 5.
Explanation and Solution
Bad memory refresh circuitry on the system
board. Remove and reinstall DIMM(s). If
error persists, replace the DIMM(s).
Parity error in the first 64 KB block of
memory. Remove and reinstall DIMM(s).
If error persists, replace DIMM(s).
Memory failure in the first 64 KB. Remove
and reinstall the DIMM(s). If error
persists, replace the DIMM(s).
Memory failure in the first 64 KB, or Timer
1 on the system board is not functioning.
Call the Customer Response Center.
The CPU on the system board generated an
error. Call the Customer Response Center.
The BIOS cannot switch to protected mode.
Call the Customer Response Center.
The CPU generated an exception interrupt.
Call the Customer Response Center.
57