Changing The System Boot Sequence - Intergraph InterServe 8000 Setup Manual

92
9. At the MS-DOS command prompt, type in the following:
flash.exe
The following messages display:
Intergraph flash programming utility
Reading 833XX.ROM.
Erasing flash EPROM
Programming flash EPROM
Flash EPROM updated.
Reboot the system by turning the power off.
Do not use ctrl-alt-del for rebooting.
10. Remove the diskette from the floppy disk drive; then power off and restart the system.
11. Press
Hit DEL if you want to run Setup
The AMIBIOS Setup program runs.
12. In the Default menu, click on the Optimal icon. Select Yes to load the values.
13. If you customized the BIOS for your system, especially to accommodate ISA adapters,
change the necessary parameters to their necessary values.
14. Exit AMIBIOS Setup and restart the system.

Changing the System Boot Sequence

To change the system boot sequence:
1. Restart the system.
2. Press
Press DEL if you want to run Setup
The AMIBIOS Setup Main Menu displays.
3. In the Setup menu, click the Advanced icon. A list of parameters displays.
4. Click the System Boot Up Sequence parameter. The Options menu displays, with a
choice of boot sequences. The default is C:, A:, CD-ROM, which designates the system
hard disk drive (C:) as the initial boot device, followed by the floppy disk drive (A:).
5. Click the A:, C:, CD-ROM option to reverse the boot sequence; then press
when the following message displays.
DEL
when the following message displays:
DELETE
.
ENTER