Changing The System Boot Sequence - Intergraph InterServe 05 Setup Manual

38
7. Type in the following to create an MS-DOS boot diskette that contains the flash utility
and the BIOS files:
md c:\temp
install.bat
8. Shut down and power off the system; then restart the system.
9. At the MS-DOS command prompt, type:
flash
The following messages display:
Intergraph flash programming utility
Reading 782XX.ROM .
Programming flash EPROM
Flash EPROM updated.
Reboot the system by turning the power off.
Do not use ctrl-alt-del for rebooting.
10. Remove the diskette from the floppy disk drive; then power off and restart the system.
11. Press
DEL
Hit DEL if you want to run Setup
12. In the Default menu, click on the Optimal icon. Select Yes to load the values.
13. If you customized the BIOS for your system, change the necessary parameters to their
previous values.
14. Exit AMIBIOS Setup and restart the system.
15. If you have ISA boards or PC Card devices installed in your system, run the SCU to
reserve the necessary system resources.

Changing the System Boot Sequence

To change the system boot sequence:
1. Restart the system.
2. Press
DELETE
Press DEL if you want to run Setup
The AMIBIOS Setup Main Menu displays.
3. In the Setup menu, click the Advanced icon. A list of parameters displays.
when the following message displays.
when the following message displays: