Installing Megaraid Power Console Software - Intergraph InterServe 80 SL System Setup

After logging on to Windows NT in VGA mode, check for the following common
configuration problems and solutions.
u
A multi-sync monitor is connected to the system, but a multi-sync monitor type is not
selected, and the display driver cannot determine this by querying the monitor. Select
an appropriate multi-sync monitor type.
u
A selected resolution, depth, or refresh rate is not supported by the multi-sync monitor.
Try using different video display settings.
u
A multi-sync monitor is selected, but a monitor with different video is connected to the
system. Select the monitor that is connected to the system.
u
The monitor selection is inappropriate for the multi-sync monitor attached to the system.
Restart the system in VGA mode, then select a new monitor as described previously.
u
A graphics resolution and color depth has been selected that exceeds installed display
memory. Restart the system in VGA mode, then open Display in the Control Panel to
reinstall and configure the display driver as described in the video display adapter
documentation delivered with the system.
Restart the system to use the reconfigured video display driver. If problems persist, contact
Intergraph Computer Systems Customer Response Center for help.

Installing MegaRAID Power Console Software

NOTE This section only applies to systems that contain the AMI MegaRAID controller.
To monitor and administer the system's RAID disk array while running Windows NT
Server, you must install the MegaRAID Power Console software after configuring Windows
NT Server. Install the software from the backup diskette you created using Version
Manager. Refer to Version Manager Help for more information about using Version
Manager.
To install MegaRAID Power Console software:
1. Log on to Windows NT using an administrative account.
2. Insert the diskette containing the MegaRAID Power Console utility into the system's
floppy disk drive.
3. Run
SETUP
4. Respond yes or no appropriately to the questions about Windows NT. At the Welcome
dialog, select Next. The MegaRAID Install Destination Path dialog displays.
. on the diskette.
EXE
17