Primary Master, Primary Slave, Secondary Master, Secondary Slave - Intergraph InterServe 80 SL System Setup

Primary Master, Primary Slave, Secondary Master, Secondary
Slave
These options control the parameters for Integrated Device Electronic (IDE) drives. The
default settings are Auto for Primary and Secondary Master, and None for Primary and
Secondary Slave.
If you are setting up a SCSI hard disk, set the IDE Device parameters to None (see your
SCSI card manual for more details). To install an IDE device, highlight the device to
configure and press
figure.
NOTE The values displayed below are for a specific drive, and will change depending on the size
and type of the drive installed on the system.
Type
This option selects the type of drive installed in the system. The default setting is Auto,
which automatically detects the drive information. If you are using a SCSI hard drive, select
None and refer to the documentation supplied with the SCSI adapter.
NOTE If BIOS Setup does not find the drive parameters when set to Auto, select User for this
parameter and complete the information manually using the settings provided in your drive
specifications.
. The IDE Device submenu displays as shown in the following
ENTER
41