Checking The System; System Power - Intergraph InterServe 80 SL System Setup

56

Checking the System

If your system is not functioning properly, first perform the following:
u
Verify the system's power state and ensure the power cord is plugged in properly. See
Chapter 4, "Operating Notes."
u
Ensure the power cords and data cables are properly attached from the base unit to the
various peripherals.
u
Refer to the accessory documentation for troubleshooting help if there are problems with
external InterRAID disk arrays, RAID disk drives, or other attached accessories.
If you cannot resolve the problem or if the instructions direct you to the Intergraph Computer
Systems Customer Response Center, call 1-800-633-7248. See the Preface of this document
for other information about contacting Intergraph Computer Systems.
When instructed to open the base unit, see the System Reference delivered with the system
for details on opening the case and working with internal components.

System Power

ERROR - Fails to power on.
Reason
Power cord not connected properly.
Power not available at the outlet.
Power not available from the UPS.
Internal power cables not connected.
Faulty power cord.
Solution
Verify that the power cord is properly
connected to the power receptacle.
Verify power to the outlet has not been
interrupted. Test the outlet with a known
working appliance.
Verify the UPS is connected and
operating properly.
Open case and ensure all power cables are
connected properly.
Replace power cord.