Fig. 3-9 Operator Panel Keys; Keys And Their Functions On The Operator Panel (Bop / Aop) - Siemens MICROMASTER 420 Operating Instructions Manual

3 Functions
3.2.3

Keys and their functions on the operator panel (BOP / AOP)

Operator Function
panel/key
Indicates
Status
Start
converter
Stop
converter
Change
direction
Jog motor
Functions
Access
parameters
Increase
value
Decrease
value
AOP menu
+
Fig. 3-9 Operator panel keys
54
The LCD displays the settings currently used by the converter.
Pressing the button starts the converter. This button is disabled by default.
Activate the button:
BOP: P0700 = 1 or P0719 = 10 ... 16
AOP: P0700 = 4 or P0719 = 40 ... 46 on BOP link
P0700 = 5 or P0719 = 50 ... 56 on COM link
OFF1 Pressing the button causes the motor to come to a standstill at the
selected ramp down rate.
Activate the button: see button "Start converter"
OFF2 Pressing the button twice (or once long) causes the motor to coast to a
standstill.
BOP: This function is always enabled
(independent of P0700 or P0719).
Press this button to change the direction of rotation of the motor. Reverse is
indicated by a minus (-) sign or a flashing decimal point. Disabled by default.
Activate the button: see button "Start converter".
In the "Ready to power-on" state, when this key is pressed, the motor starts and
rotates with the pre-set jog frequency. The motor stops when the button is
released. Pressing this button when the motor is running has no effect.
This button can be used to view additional information.
It works by pressing and holding the button. It shows the following, starting from
any parameter during operation:
1. DC link voltage (indicated by d – units V).
2. output current. (A)
3. output frequency (Hz)
4. output voltage (indicated by o – units V).
5. The value selected in P0005 (If P0005 is set to show any of the above (1 - 4)
then this will not be shown again).
Additional presses will toggle around the above displays.
Jump Function
From any parameter (rxxxx or Pxxxx) a short press of the Fn button will
immediately jump to r0000, you can then change another parameter, if required.
Upon returning to r0000, pressing the Fn button will return you to your starting
point.
Acknowledgement
If alarm and fault messages are present, then these can be acknowledged by
pressing key Fn.
Pressing this button allows access to the parameters.
Pressing this button increases the displayed value.
Pressing this button decreases the displayed value.
Calls the AOP menu prompting (this is only available for AOP).
Effects
MICROMASTER 420 Operating Instructions
6SE6400-5AA00-0BP0
Issue 07/04