Fig. 3-5 Connectors - Siemens MICROMASTER 420 Operating Instructions Manual

3 Functions
A connector is a value (16 or 32 bit), which can include a normalized quantity
(without dimension) as well as also a quantity with associated units. Connectors
always refer to functions whereby they are sub-divided into connector inputs and
connector outputs (refer to Fig. 3-5). Essentially the same as the binectors, the
connector inputs are characterized by a "P" parameter plus attribute "CI" (e.g.:
P0771 CI: DAC); while the connector outputs are always represented using an "r"
parameter plus attribute "CO" (e.g.: r0021 CO: Smoothed output frequency).
As can be seen from the examples above, connector parameters have the
following abbreviations in front of the parameter names:
CI Connector Input, signal sink ("P" parameters)
The CI parameter can be interconnected with a connector output as source,
by entering the parameter number of the connector output (CO parameter)
as value in the CI parameter (e.g.: P0771 = 21).
CO Connector Output, signal source ("r" parameters)
The CO parameter can be used as source for CI parameters. For the
particular interconnection, the CO parameter number must be entered in the
CI parameter (e.g.: P0771 = 21).
Further, MICROMASTER has "r" parameters where several binector outputs are
combined in a word (e.g.: r0052 CO/BO: Status word 1). This feature reduces, on
one hand, the number of parameters and simplifies parameterization via the serial
interface (data transfer). This parameter is further characterized by the fact that it
does not have any units and each bit represents a digital (binary) signal.
As can be seen from the examples of parameters, these combined parameters
have the following abbreviation in front of the parameter names:
CO/BO Connector Output / Binector Output, signal source ("r"
parameters)
CO/BO parameters can be used as source for CI parameters and BI
parameters:
a) In order to interconnect all of the CO/BO parameters, the parameter
b) When interconnecting a single digital signal, in addition to the CO/BO
Abbreviation and symbol
CI
CO
CO
BO
Fig. 3-5
48
number must be entered into the appropriate CI parameter (e.g.:
P2016[0] = 52).
parameter number, the bit number must also be entered into the BI
parameter (e.g.: P0731 = 52.3)
Name
Connector input
(signal receiver)
Connector output
(signal source)
Binector/connector
output
(signal source)
Connectors
Function
Data flow
Pxxxx
Function
CI: ...
Data flow
rxxxx
Function
CO: ...
Data flow
rxxxx
Functions
CO/BO: ...
MICROMASTER 420 Operating Instructions
6SE6400-5AA00-0BP0
Issue 07/04