Jog - Siemens MICROMASTER 420 Operating Instructions Manual

3 Functions
3.10

JOG

Parameter range:
Warnings
Faults
Function chart number:
The JOG function is used as follows:
To check the functionality of the motor and drive inverter after commissioning
has been completed (the first traversing motion, checking the direction of
rotation, etc.)
Positioning a drive / a driven load into a specific position
Traversing a drive, e.g. after a program has been interrupted
The drive is traversed using this function by entering fixed frequencies P1058,
P1059. The JOG mode can be selected either using the operator panel (refer to
Section 3.1.3), digital inputs or also via the serial interfaces (refer to the example).
An ON/OFF command is not used to move the drive, but when the "JOG keys" are
pressed. These "JOG keys" are selected using the BICO parameters P1055 and
P1056.
DIN
BOP
USS
BOP link
USS
COM link
CB
COM link
Fig. 3-35
104
P1055 – P1061
A0923
-
FP5000
"1"
JOG right
P1055
"0"
(0)
"1"
JOG left
P1056
"0"
(0)
f
P1082
P1058
P1059
-P1082
JOG counter-clockwise and JOG clockwise
A0923
MICROMASTER 420 Operating Instructions
6SE6400-5AA00-0BP0
Issue 07/04
A0923
t
t
t