Korg D1600mkII Owner's Manual page 45

Select the "Ch8" icon, and rotate the [VALUE] dial to
select "INPUT 8."
The input from the [GUITAR IN] jack has now been
assigned to mixer channel 8.
3. Assign the input sound to mixer channel 8.
Press the track 8 [TRACK STATUS] key to set it to
INPUT (LED lit orange).
4. Use the trim to adjust the input level.
Press the [METER/TRACK VIEW] key. Press the " "
button to access the dialog box.
Press the "PreFaderLev" radio button, and press the
"OK" button.
Play your guitar to input sound, and the level meter
of Ch.8 will move accordingly. Adjust the INPUT 8
[TRIM] knob while watching the level meter. Raise
the [TRIM] as high as possible without the level
reaching CLP, while playing your guitar.
5. Audition the sound.
Set the [MASTER] and [CHANNEL 8] faders to unity
gain (0 dB).
Access the [SOLO/MONITOR] "Monitor" tab page.
Press the "MasterLR" button to turn it "On" (high-
lighted).
Gradually raise the [PHONES LEVEL] knob or
[MONITOR OUT LEVEL] knob, and listen to the
sound in your headphones or monitor system.
Connect a mic to [INPUT 2] and assign it to
mixer channel 2
1. Connect a mic.
Set the INPUT 2 [TRIM] to the minimum (+4 dB),
lower the D1600mkII's [MASTER] fader, and connect
a mic to the [INPUT 2] jack.
If you are using a condenser mic, turn on phantom
power for [INPUT 2] after you connect the mic.
Turn phantom power on only if you are using a
condenser mic.
Phantom power must be turned on after connect-
ing the condenser mic. If you connect or discon-
nect the mic with phantom power turned on,
your equipment may be damaged.
2. Specify the input channel.
Access the [INPUT/TUNER] "Ch1–8" tab page.
Select the "Ch2" icon, and rotate the [VALUE] dial to
select "INPUT 2."
The input from the [INPUT 2] has now been assigned
to mixer channel 2.
3. Assign the input sound to mixer channel 2.
Press the track 2 [TRACK STATUS] key to select
INPUT (the LED will light orange).
4. Use trim to adjust the input level.
Press the [METER/TRACK VIEW] key.
Press the " " button to access the dialog box. Choose
"PreFaderLev," press the "OK" button.
When you input sound into the mic, the Ch2 level
meter will move accordingly.
Adjust the input 2 [TRIM] knob while you watch the
level meter. Raise the [TRIM] as high as possible.
Don't allow the level to reach CLP when you produce
your loudest sound.
5. Audition the sound.
Set the [MASTER] and [CHANNEL 2] faders to unity
gain (0 dB).
Access the [SOLO/MONITOR] "Monitor" tab page.
Press the "MasterLR" button to turn it "On" (high-
lighted).
Gradually raise the [PHONES LEVEL] knob or
[MONITOR OUT LEVEL] knob, and listen to the
sound in your headphones or monitor system.
37