Rear Panel - Korg D1600mkII Owner's Manual

3. Rear panel

1
1 [AC] connector
Connect the included power supply cable here.
2 [Main power] switch
This turns the main power on/off.
When the [Main power] switch is turned on, the
D1600mkII will be in standby mode. In standby
mode, you can press the [POWER] key to turn on the
power of the D1600mkII. While the D1600mkII is
operating, you can use the [POWER] key to shut
down, and then turn the main power off to turn the
power off completely.
To turn off the power, you must first press the
[POWER] key to perform the shutdown opera-
tion. Never turn off the [Main power] switch or
disconnect the power cable until shutdown has
been completed.
If you turn off the [Main power] switch or dis-
connect the power cable before shutdown has
been completed, data and user settings may be
lost, or the hard disk may be damaged.
3 [INPUT 1], [INPUT 2], [INPUT 3], [INPUT 4] jacks
Audio sources such as mic or line (keyboard etc.) can
be connected here.
Both balanced XLR and balanced 1/4" TRS phone
jacks are provided.
Unbalanced phone plugs can also be connected.
+48V phantom power is provided on the XLR jacks
so that you can use condenser mics.
If you connect the phone jack, you will not be
able to input from the XLR jack. If you want to
use the XLR jack, don't connect anything to the
phone jack.
6
2
5
2: HOT
1: GND
3: COLD
Phantom power switch
4
6 7 8 9 10
Balanced phone plug
If a condenser mic is connected or disconnected
with the phantom power switch on, damage to
your equipment may occur. For this reason,
always turn the phantom power switch off before
connecting a condenser mic.
Never connect an unbalanced mic or device
when the phantom power switch is on. Doing so
may damage your equipment.
4 [INPUT 5], [INPUT 6], [INPUT 7], [INPUT 8] jacks
Mic/line (e.g., keyboard) sources can be input here.
These are balanced 1/4" TRS phone jacks.
Unbalanced phone jacks can also be connected.
If you connect a plug to the [GUITAR IN] jack, no
input signal will be received from the [INPUT 8]
jack. If you wish to use the [INPUT 8] jack, dis-
connect the plug from the [GUITAR IN] jack.
5 [FOOT SW] jack
When your hands are occupied with playing an
instrument, you can use a foot switch to control basic
operations of the D1600mkII recorder.
A foot switch can be used to start/stop the playback,
start/end manual punch-in recording, register a
mark, or to record tap tempo.
Connect the foot switch (optional PS-1) to this jack.
6 [EXPRESSION PEDAL] jack
You can use a pedal to control a specified parameter
of an insert effect. You can control the parameter in
realtime while you play or record.
Connect an expression pedal (separately sold option,
EXP-2, XVP-10 etc.) to this jack.
3
11 12 13 14 15
Unbalanced phone plug
GND COLD HOT GND HOT