Modulation Mo1- Mo7 - Korg D1600mkII Owner's Manual

11: DL4: St.Modulation Delay
(Stereo Modulation Delay)
This stereo delay uses an LFO to sweep the delay time. The pitch
also varies. You will obtain a delay sound with swell and shim-
mering.
LFO (LFO Waveform).......... TRI, SIN Selects LFO Waveform
Shape (LFO Shape)....... –100...+100 Determines how much the LFO
*Speed (LFO Frequency [Hz]) ............
0.02...20.0
LPhase (L LFO Phase [degree]) ..... –
180...+180
RPhase(R LFO Phase [degree]) ..... –
180...+180
*LDepth (L Depth) ................... 0...200 Sets the depth of the left LFO
*RDepth (R Depth) .................. 0...200 Sets the depth of the right LFO
LTime (L Delay Time [msec]).. 0...500 Sets the delay time for the left
RTime (R Delay Time [msec]) 0...500 Sets the delay time for the right
LFback (L Feedback) ..... –100...+100 Sets the feedback amount of left
RFback (R Feedback) .... –100...+100 Sets the feedback amount of right
Mix (Wet/Dry) ........–Wet...–1:99, Dry,
1:99...Wet
: L LFO Phase [degree], : R LFO Phase [degree]
"L LFO Phase" and "R LFO Phase" specify the phase difference
between the two LFOs when they are reset. This allows the pitch
change of the sweep to be set independently for left and right.
12: DL5: St.Dynamic Delay
This stereo delay controls the level of delay according to the
input signal level. You can use this as a ducking delay that
applies delay to the sound only when you input signals at a high
velocity or only when the volume level is low.
Contrl (Control Target) None, Out, FB Selects from no control, output,
Polrty (Polarity)............................ +, – Reverses level control
Thrshl (Threshold).................. 0...100 Sets the level to which the effect
Offset (Offset) ........................ 0...100 Sets the offset of level control
Attack (Attack)........................ 1...100 Sets the attack time of level con-
Relse (Release) ..................... 1...100 Sets the release time of level
LTime (L Delay Time [msec]).. 0...680 Sets the delay time for the left
RTime (R Delay Time [msec]) 0...680 Sets the delay time for the right
Fdback (Feedback) ........ –100...+100 Sets the feedback amount
HiDamp (High Damp [%]) ...... 0...100 Sets the damping amount in the
LoDamp (Low Damp [%])....... 0...100 Sets the damping amount in the
Spread (Spread) ............ –100...+100 Sets the width of the stereo
Mix (Wet/Dry) ....Dry, 1:99...99:1, Wet Sets the balance between the
: Control Target
This parameter selects no level control, delay output control (effect
balance), or feedback amount control.
: Polarity, :Threshold, :Offset, :Attack, :Release
The "Offset" parameter specifies the value for the "Control Target"
parameter (when level control is not being applied), expressed as a
ratio relative to the parameter setting. The parameter setting will be
the "Wet/Dry" value if "Control Target"="Out," or the "Feedback"
value if "Control Target"="FB."
waveform is changed
Sets the LFO speed
Sets the phase obtained when
the left LFO is reset
Sets the phase obtained when
the right LFO is reset
modulation
modulation
channel
channel
delay
delay
Sets the balance between the
effect and dry sounds
(Stereo Dynamic Delay)
and feedback
is applied
trol
control
channel
channel
high range
low range
image of the effect sound
effect and dry sounds
When "Polarity" is "+", the "Control Target" value is obtained by
multiplying the parameter value by the "Offset" value (if the input
level is below "Threshold"), or will equal the parameter value if the
input level exceeds the threshold.
When "Polarity" is "–", the Control Target value will equal the
parameter value if the input level is below "Threshold", or is
obtained by multiplying the parameter value by the "Offset" value if
the input level exceeds "Threshold."
The "Attack" and "Release" parameters specify attack time and
release time of delay level control.
13: DL6: St.Auto Panning Delay
(Stereo Auto Panning Delay)
This stereo delay effect pans the delay sound left and right using
the LFO.
LTime (L Delay Time [msec])..0...680 Sets the delay time for the left
LFback (L Feedback)......–100...+100 Sets the feedback amount for the
RTime (R Delay Time [msec]) 0...680 Sets the delay time for the right
RFback (R Feedback) ....–100...+100 Sets the feedback amount for the
HiDamp (High Damp [%]).......0...100 Sets the damping amount in the
LoDamp (Low Damp [%]) .......0...100 Sets the damping amount in the
LFO (LFO Waveform) .......... TRI, SIN Selects LFO Waveform
Shape (LFO Shape) .......–100...+100 Determines how much the LFO
Phase (LFO Phase [degree]) ..........–
180...+180
*Speed(Panning Frequency [Hz]) .......
0.02...20.0
*Depth (Panning Depth)...........0...100 Sets the panning width
Mix (Wet/Dry) ... Dry, 1:99...99:1, Wet Sets the balance between the
Modulation MO1– MO7
Category: Modulation-type effects
14: MO1: St.Chorus
(Stereo Chorus)
This effect adds thickness and warmth to the sound by modulat-
ing the delay time of the input signal. A two-band equalizer can
be used to adjust the tone of the effect sound. You can control
the spaciousness of the sound by offsetting the phase of the left
and right LFOs from each other.
LFO (LFO Waveform) .......... TRI, SIN Selects LFO Waveform
Phase (LFO Phase [degree]) ..........–
180...+180
*Speed (LFO Frequency [Hz]) ............
0.02...20.0
LDly (L Pre Delay [msec]) ..0.0...50.0 Sets the delay time for the left
RDly (R Pre Delay [msec]) .0.0...50.0 Sets the delay time for the right
*Depth (Depth).........................0...100 Sets the depth of LFO modula-
EQTrim (EQ Trim) ...................0...100 Sets the EQ input level
LEQG (Pre LEQ Gain [dB]) .............–
15.0...+15.0
HEQG (Pre HEQ Gain [dB]) ............–
15.0...+15.0
Mix (Wet/Dry) ....... –Wet...–1:99, Dry,
1:99...Wet
: L Pre Delay [msec], : R Pre Delay [msec]
Setting the left and right delay time individually allows you to con-
channel
left channel
channel
right channel
high range
low range
waveform is changed
Sets the LFO phase difference
between the left and right
Sets the panning speed
effect and dry sounds
Sets the LFO phase difference
between the left and right
Sets the LFO speed
channel
channel
tion
Sets the gain of Low EQ
Sets the gain of High EQ
Sets the balance between the
effect and dry sounds
139