Eq/Phase; P1 Eq1-4: Eq Settings For Mixer Channels 1-4; P2 Eq5-8: Eq Settings For Mixer Channels 5-8; P3 Eq9-12: Eq Settings For Mixer Channels 9-12 - Korg D1600mkII Owner's Manual

18. EQ/PHASE

P1 Eq1–4: EQ settings for mixer
channels 1–4
Here you can apply EQ (equalizer) to the playback of tracks
1–4.
Use these settings when you wish to apply EQ to the play-
back.
The EQ has three bands. High EQ and low EQ are shelving
type, and the mid EQ is a peaking type with adjustable cutoff
frequency.
5
1
3 4 2
1. TrackLevelMeter ......... (1, 2, 3, 4/CLP, –8, –18, –42dB)
This shows the input level from each track.
The horizontal axis indicates the channel, and the
vertical axis indicates the level.
2. HighEq......................... [(Fc=10kHz)–15.0...+15.0(dB)]
Set the high EQ gain.
You can cut/boost over a range of –15.0 – +15.0 dB at a
10 kHz cutoff frequency.
3. MidFc ......................................... [100Hz...20.0k (Hz)]
Specifies the center frequency of the mid EQ.
4. MidEq ...........................................[–15.0...+15.0(dB)]
Set the mid EQ gain.
You can cut/boost over a range of –15.0 – +15.0 dB at the
cutoff frequency specified by "MidFc."
5. LowEq..........................[(Fc=100Hz)–15.0...+15.0(dB)]
Set the low EQ gain.
You can cut/boost over a range of –15.0 – +15.0 dB at a
100 Hz cutoff frequency.
6. Pair ...........................................................................
Enable pairing for adjacent mixer channels. For details,
refer to "P1 Ch1–8: Select the inputs for mixer channels
1–8" "Pair" (→p.123).
P2 Eq5–8: EQ settings for mixer
channels 5–8
Here you can apply EQ (equalizer) to the playback of tracks
5–8.
Refer to "P1 Eq1–4: EQ settings for mixer channels 1–4."
P3 Eq9–12: EQ settings for mixer
channels 9–12
Here you can apply EQ (equalizer) to the playback of tracks
9–12.
Refer to "P1 Eq1–4: EQ settings for mixer channels 1–4."
P4 Eq13–16: EQ settings for mixer
channels 13–16
Apply EQ (equalizer) to the playback of tracks 13–16.
Refer to "P1 Eq1–4: EQ settings for mixer channels 1–4."
P5 Phase: Phase settings for mixer
channels
Here you can invert the phase of each channel.
This setting applies to the playback tracks. If an audio device
is input in stereo via a jack whose hot and cold conductors
are reversed, their stereo position may be blurred, or
portions of the sound may be cancelled. This setting lets you
6
invert the phase to correct such situations.
1. Phase ............................................................... [N, R]
N (NormalPhase): The phase of this channel will not be
inverted. Normally you will leave this at "N."
R (ReversePhase): The phase of this channel will be
inverted.
2. Pair ...........................................................................
Enable pairing for adjacent mixer channels. For details,
refer to "P1 Ch1–8: Select the inputs for mixer channels
1–8" "Pair" (→p.123).
1
2
125