P2 Monitor: Monitor Settings - Korg D1600mkII Owner's Manual

P2 Monitor: Monitor settings

Here you can select the audio that will be sent from the mon-
itor output ([MONITOR OUT L/R] jacks) and the headphone
output ([PHONES] jack).
1
4 2
1. MasterLr ...................................................... [On, Off]
Sends the master LR bus to the monitor output. Nor-
mally you will turn this "On."
On: This signal will be sent from monitor
output.
Off: This signal will not be sent from monitor
output.
If solo is turned on for a signal in the "Solo" tab page,
you will be unable to turn this setting "On." In order
to turn this "On," you must first turn solo "Off" in
the "Solo" tab page.
2. Solo............................................................. [On, Off]
If a signal is being soloed in the "Solo" tab page, this set-
ting will automatically be "On."
On: This signal will be sent from monitor
output.
Off: This signal will not be sent from monitor
output.
3. Rhythm ........................................................ [On, Off]
Selects the bus to which the rhythm sound will be sent.
On: The rhythm will be sent to the monitor
LR bus.
Use this setting when you want to output the track
audio from the [MASTER OUT L/R] jacks and listen to
the rhythm only through headphones, for example
during a live performance.
Off: The rhythm will be sent to the master LR
bus.
When using bounce-recording, the rhythm will be
recorded if you turn this "Off."
If in the [RHYTHM] "SetUp" tab page you set
"Rhythm" to "Off," the rhythm sound will not be
sent to either bus, regardless of this setting.
4. Cue ............................................................. [On, Off]
Sends the channel specified by "Level" to the monitor
output. When recording, you can select this if you want
to adjust the monitor volume and panning for the conve-
nience of the performer without affecting the recording
level.
On: The signal will be sent from monitor
output.
Off: The signal will not be sent from moni-
tor output.
If solo is turned on for a signal in the "Solo" tab page,
you will be unable to turn this setting "On." In order
to turn this "On," you must first turn solo "Off" in
the "Solo" tab page.
132
5 3
5. Level (Cue Level).........................................................
Sets the level and panning for each mixer channel when
"Cue" is turned "On" in "SelectMonitor."
Press the "Level" button to open the "Cue setting"
dialog box, and make the desired settings.
5a
5b
6
5a. Pan (Ch1–6)/Balance(Ch7–12).... [L63...CNT...R63]
Adjusts the panning or balance at which each channel
cue signal is sent to the monitor output.
5b. Cue ....................................................[000...100]
Sets the volume at which each channel cue signal is sent
to the monitor output.
6. AutoIn ......................................................... [On, Off]
For mixer channels whose [TRACK STATUS] is REC,
this specifies whether the audio sent to the monitor out-
put will be the external input that is assigned in the
"Input" tab page or the sound from the playback track.
On: For mixer channels whose [TRACK STA-
TUS] is REC, you will hear the sound of the track during
playback, and the sound of the external input while
recording or stopped.
Off: For mixer channels whose [TRACK STATUS]
is REC, you will always hear the sound of the external
input.