Korg EXB-MOSS Manual page 21

Cross Modulation
This uses a modulator to frequency-modulate a carrier.
You can select one of four waveforms as the carrier.
In general, a pitch envelope is applied to the modula-
tor. A carrier oscillator is built-in to the Cross
Modulation OSC. You can select the output of the
other oscillator etc. as the modulator.
By modifying the pitch of the modulator oscillator,
you can produce characteristic cross-modulation
effects.
1–3a
1–3b
1–3a: Wave
Input [OSC2(1), Sub OSC, Noise, Filter1, Filter2]
Specifies the modulator.
Carrier [Saw, Square, Triangle, Sine]
Specifies the carrier waveform.
Wave Edge
Specifies the amount of high frequency harmonics for
the carrier waveform. As this value is decreased, the
sound will have less high-frequency harmonics, and as
it approaches 0 the volume will also decrease.
1–3b: Modulation Depth
Depth
Specifies the depth of modulation. At a setting of 0,
the carrier waveform will be output without change.
AMS1 (Alternate Modulation Source 1)
Selects a modulation source 1 ( p.48 of this manual)
that will control " Depth."
Intensity (Modulation Depth AMS1 Intensity)
Specifies the depth and direction of the effect of
"AMS1."
22
[0...99]
[0...99]
[Off...MIDI:CC#83]
[–99...+99]
AMS2 (Alternate Modulation Source 2)
Selects a modulation source 2 ( p.48 of this manual)
that will control "Depth."
Intensity (Modulation Depth AMS2 Intensity)
Specifies the depth and direction of the effect of
"AMS2."
[Off...MIDI:CC#83]
[–99...+99]