Korg EXB-MOSS Manual page 43

Fade
Specifies the time over which the amplitude of the
LFO will increase from 0 until it reaches the maxi-
mum value.
5–1b: Frequency Modulation
You can use two alternate modulation sources to
control the frequency of the LFO.
AMS1 (Alternate Modulation Source 1)
Select a modulation source 1 ( p.48 of this manual)
that will control the LFO frequency.
Intensity (Frequency AMS1 Intensity)
Specifies the depth and direction of the effect that
"AMS1" will have on the "Frequency" value.
AMS2 (Alternate Modulation Source 2)
Selects a modulation source 2 ( p.48 of this manual)
that will control the LFO frequency.
Intensity (Frequency AMS2 Intensity)
Specifies the depth and direction of the effect that
"AMS2" will have on the "Frequency" value.
5–1c: Frequency MIDI/Tempo Sync.
MIDI/Tempo Sync.
Checked: The LFO frequency will synchronize to the
tempo (MIDI Clock). In this case, the settings of "5–
1a: Frequency" and "5–1b: Frequency Modulation"
will have no effect.
Base Note
Times
If "MIDI/Tempo Sync." is checked, these parameters
specify the "Base Note" note value and a multiple
"Times" relative to the " (tempo)." These parameters
will determine the frequency of the OSC1 LFO1. For
example if "Base Note" is (quarter note) and
"Times" is 04, the LFO will cycle once every four
beats.
Even if you change the " (Tempo)" of the arpeggiator
or sequencer, the LFO will always cycle once every
four beats.
If the Global mode parameter "1–1a: MIDI
Clock" ( Parameter Guide p.118) is set to
Internal, the LFO will synchronize to the
tempo specified by the program. If it is set to
External MIDI or External PC I/F, the LFO
will synchronize to the MIDI Clock messages
received from an external MIDI device.
44
[0...99]
[Off...MIDI:CC#83]
[–99...+99]
[Off...MIDI:CC#83]
[–99...+99]
[
[01...16]
5–2: LFO 2
5–3: LFO 3
5–4: LFO 4
LFO 2, LFO 3, and LFO 4 have the same parameter as
LFO 1. Refer to "5–1: LFO 1 "
]