Korg EXB-MOSS Manual page 27

1–3c: Reed Character
AMS (Alternate Modulation Source)
Selects a modulation source ( p.48 of this manual) that
will modulate the characteristics of the reed.
Intensity (Reed AMS Intensity)
Specifies the depth of the modulation effect that
"AMS" will have on the reed.
1–3d: Bell Character
Tone
Specifies the tone of the bell. As this value is in-
creased, the low frequency portion will disappear,
producing a less solid tone.
Reso
Specifies the level at which the frequency region in
the area of the "Tone" will be boosted. As this value
is increased, the resonance effect will become stronger.
1–3e: Wave Shape
Type (Wave Shape Table Type)
Use the radio buttons to select the wave shaping
table which will modify the input waveform. For the
way in which the table will modify the waveform,
refer to the Wave Shape diagram shown in Standard
( page 16 of this manual).
Offset
Specifies the offset value that will be added to the
Reed OSC signal that is input to wave shaping.
Shape
Specifies the character of the table that will shape the
input waveform. For details on how the waveform will
change, refer to the "Shape" diagram ( page 16 of
this manual) for the Standard OSC.
AMS (Alternate Modulation Source)
Selects a modulation source ( p.48 of this manual)
that will control "Shape."
Intensity (Shape AMS Intensity)
Specifies the depth and direction of the effect of "AMS."
28
1–3f: Peaking EQ
Frequency
[Off...MIDI:CC#83]
Specifies the center frequency of the range that will be
boosted or attenuated by the Peaking EQ. Increasing
this value will raise the center frequency.
[–99...+99] Q
Specifies the width of the Peaking EQ frequency
band. Increasing this value will narrow the frequency
band that is boosted or attenuated.
Gain
Specifies the amount by which the range specified by
[0...99]
"Frequency" and "Q" will be boosted or attenuated.
[0...99]
[Clip/Reso]
[–99...+99]
[0...99]
[Off...MIDI:CC#83]
[–99...+99]
[0...49]
[0...29]
[–18...+18]