Program P2: Edit-Pitch - Korg EXB-MOSS Manual

Program P2: Edit-Pitch

2-1: OSC1 P. Mod
(Oscillator 1 Pitch Modulation)
2–1a
2–1b
2–1a: Pitch Slope
Specifies how pitch will change in relation to the
keyboard (key.)
Center Key
Specifies the key at which Lower/Higher keyboard
tracking will begin to apply.
You can also input a value by playing a note
on the keyboard while you hold down the
[ENTER] key.
Ramp Low
Specifies the depth and direction of the pitch change
that will occur for notes below the "Center Key."
Ramp High
Specifies the depth and direction of the pitch change
that will occur for notes above the Center Key.
When Low Slope and High Slope are set to +2.0,
playing one octave upward from the Center Key will
cause the pitch to rise two octaves.
With a setting of –1.0, playing one octave upward will
cause the pitch to fall one octave. With a setting of
0.0, the notes in the respective areas will produce the
same pitch as the Center Key. To play pitches
normally, set this parameter to +1.0.
Pitch
C9
1.0
C-1
C-1
Center Key
36
[C–1...G9]
[–1.00...+2.00]
[–1.00...+2.00]
+2.0 +1.0
0.0
Key
C4 C9
2–1b: Pitch Modulation
Specifies the pitch Modulation.
AMS1 (Alternate Modulation Source 1)
Selects a modulation source 1 ( p.48 of this manual)
which will modify the pitch (e.g., apply vibrato).
Intensity (Pitch AMS1 Intensity)
Specifies the depth and direction of the pitch change
that will be controlled by "AMS1."
AMS(AMS1 Intensity Alternate Modulation Source)
Specifies the controller ( p.48 of this manual) that
will control the "Intensity (Pitch AMS1 Intensity)."
Intensity (AMS1 Int AMS Intensity)
Specifies the depth of the pitch modulation effect
controlled by "AMS1."
AMS2 (Alternate Modulation Source 2)
Selects a modulation source 2 ( p.48 of this manual)
which will modify the pitch (e.g., apply vibrato).
Intensity (Pitch AMS2 Intensity)
Specifies the depth of the pitch modulation effect
controlled by "AMS2."
2–2: OSC2 P.Mod
(Oscillator 2 Pitch Modulation)
2–3: SubOSC P.Mod
(Sub Oscillator Pitch Modulation)
OSC2 P.Mod and SubOSC P.Mod, have the same
parameter as OSC 1. Refer to "2–1: OSC1 P. Mod"
2–4: Common P.Mod
2–4a
2–4b
2–4c
[Off...MIDI:CC#83]
[–99...+99]
[Off...MIDI:CC#83]
[–99...+99]
[Off...MIDI:CC#83]
[–99...+99]