Download Print this page

Advertisement

Since the filter characteristics differ from the filter
type of the "3–1: Filter 1 ," "3–3: Filter 2" the
resulting effect will be different even if "Filter Type,"
"Frequency" and "Resonance" settings are identical.
1–5b: Frequency Modulation
AMS1 (Alternate Modulation Source 1)
Selects a modulation source 1 ( p.48 of this manual)
that will control the "Frequency."
Intensity (Cutoff Frequency AMS1 Intensity)
Specifies the depth and direction of the effect of
"AMS1."
AMS2 (Alternate Modulation Source 2)
Selects a modulation source 2 ( p.48 of this manual)
that will control the "Frequency."
Intensity (Cutoff Frequency AMS2 Intensity)
Specifies the depth and direction of the effect of
"AMS2."
1–6: OSC Mixer
The mixer allows you to set the levels at which the
five signals (OSC 1, OSC 2, Sub OSC, Noise Genera-
tor, Feedback) will be combined into the two mixer
outputs. You can also select a modulation source to
control each level, and specify its intensity.
1–6a
1–6b
1–6a: Mixer1
These parameters adjust the level at which the oscillator
1 signal is output from mixer output 1, and specify a
modulation source that will control this level.
OSC1 (OSC1 Output Level)
Specifies the signal level that will be output to mixer
output 1.
34
AMS (Alternate Modulation Source)
Selects a modulation source ( p.48 of this manual)
that will control "output level."
Intensity (Level AMS Intensity)
Specifies the depth and direction of the effect of
"AMS."
With positive (+) settings, higher values of the
[Off...MIDI:CC#83]
modulation source will increase the "output level."
With negative (–) settings, lower values of the
modulation source will increase the "output level." If
EG or LFO has been selected as the "AMS", positive
(+) settings will cause the original phase of the EG or
[–99...+99]
LFO to be used, and negative (–) settings will invert
the phase.
OSC2 (OSC2 Output Level)
These parameters adjust the level at which the
[Off...MIDI:CC#83]
oscillator 2 signal is output from mixer output 1, and
specify a modulation source that will control this
level.
Sub OSC
[–99...+99]
These parameters adjust the level at which the sub
oscillator signal output is output from mixer output 1,
and specify a modulation source that will control this
level.
Noise
These parameters adjust the level at which the output
of the noise generator is output from mixer output 1,
and specify a modulation source that will control this
level.
Feedback
These parameters adjust the level at which the
feedback from the amp section is output from mixer
output 1, and specify a modulation source that will
control this level.
1–6b: Mixer2
These parameters adjust the level at which the
oscillator 1 signal is output from mixer output 2, and
specify a modulation source that will control this
level.
Refer to the above explanation of "1–6a: Mixer 1."
[00...99]
Raising the Feedback level excessively may
cause the sound to distort.
[Off...MIDI:CC#83]
[–99...+99]

Advertisement

   Also See for Korg EXB-MOSS

   Related Manuals for Korg EXB-MOSS

Comments to this Manuals

Symbols: 0
Latest comments: