Memory SwTch Data LSt - JUKI APW-895/IP-420 Instruction Manual

(2) Memory switch data list
1 Level 1
Memory swtch data (level 1) are the moton data that the sewng machne has n common and the data
that operate on all sewng patterns n common.
No.
change-over of the position of clamp foot after sewing end
Position of clamp foot after sewing end is selected from Stop at front
end/Return to medum/Clamp return/Stop at rear end.
Front end motion start waiting time
Waiting time up to the start of front end motion of clamp foot is set.
＊ It is possible to set only when
Number of times of feeding of automatic interlining supplying at
sewing start
Number of times of feeding of automatic interlining supplying device at
sewng start s set.
＊ It is possible to set only when
ng opton s used.
Feeding length of automatic interlining supplying at sewing end
Feeding length of automatic interlining supplying device at sewing end
s set.
＊ It is possible to set only when
ng devce s used.
thread trimming timing
Thread trimming timing after sewing is selected from Standard/Me-
dium/Longest and length of thread at sewing end is adjusted.
＊ When
dard value "0", needle thread may not be cut.
Stacker timer 2
Waiting time from the start of clamp motion to hold material on the
stacker base to release the materal presser s set.
＊ It is possible to set only when
used.
. . . Item that is not displayed due to other setting state.
Item
Stop at front end
Clamp return
is set to the stop at front end.
automatc nterlnng supply-
automatc nterlnng supply-
Standard 0
Longest 2
Zipper attachment is mounted and the setting is set to stan-
clamp bar stacker opton s
− 60 −
Setting range
/
Edit unit
- - -
Return to medum
Stop at rear end
0.50 to
9.99
/
0.01 sec.
2 to 9
/
1
0 to 99.9
/
0.1mm
- - -
Medum 1
0.00 to
9.99
/
0.01 sec.
Initial value
3.00 sec.
3
0mm
0.70 sec.