Grease-Up Procedure - JUKI APW-895/IP-420 Instruction Manual

(1) Grease-up procedure

2
1
7
3
8
1 Remove four setscrews 1 and take out face
2 Replenishment of grease to the center knife
4
• Apply grease to both planes of guides 3 , knife
• Knife bar 5 moves up and down by moving
5
6
3 Replenishment of grease to the needle bar
9
!2
!1
!0
− 97 −
plate 2 .
section
bar metal, upper 4 , and knife bar metal, lower 6 .
cylinder joint 7 up and down in the state that air
is not supplied. Apply grease to the metal so as
to infiltrate the inside.
section
Apply grease to thread take-up lever 8 , needle
bar upper section 9 , needle bar lower section
!0 , needle bar !1 and needle bar !2 .