Installing Sa-120 (Interlining Supplying Device) (Optional Part No. : 40045772) - JUKI APW-895/IP-420 Instruction Manual

13. INSTALLING SA-120 (INTERLINING SUPPLYING DEVICE)
(OPTIONAL PART NO. : 40045772)
CAUTION
:
Turn OFF the power before starting the work so as to prevent accidents caused by abrupt start of the
sewing machine.
2
1
Guide plate
2 Set interlining as shown in the figure above.
The roll core that can be used is 40 to 70 mm wide and 00 mm in roller diameter (max.).
3 Pass the interlining between guide B and guide A and roller, and route it up above the table.
Feed the interlining up to the roller section using the notch of the guide plate.
4 Adjust the lateral position of two guides, two guide pins and side plate (on the right) to allow the
interlining to be fed straight up above the sewing table.
5 Position the set collar on the left-hand side to allow the side plate to lightly hold the interlining by
spring. Then fix the set collar there.
* It cannot be used for the long and wide
type.
1 Fix interlining installing plate 1 to the
machine frame with two screws 2 .
Sewing table
Notch
Guide A
Guide B
Guide B
Spring
Set collar
Side plate
Interlining
−  −
Roller