HP TR3271 Programming Manual page 82

COMMANDS AND RESPONSES
ADD Command
ZCOM-ERR-MAX-LIMIT-EXCEEDED (-12)
Your management application attempted to add more than 253
subdevices on a single line.
many as 255 subdevices; however, two subdevices are reserved:
#ZSPI and #DEBUG.
ZCOM-ERR-CMD-MISMATCH (-4)
Your management application tried to add a process or a line
by using the object type ZCOM-OBJ-PROC or ZCOM-OBJ-LINE.
command is valid only for the object type ZCOM-OBJ-SU.
ZCOM-ERR-CMD-INV-IN-SUMSTATE (-3)
Your management application tried to add a subdevice while the
line was in the DIAGNOSING summary state.
in the STOPPED or STARTED summary state to process the ADD
command.
ZTR3-ERR-ALRDY-USING-ADDR (6)
Your management application attempted to add a subdevice at an
address already in use by another object.
using a value for the ZADDR field that has not been previously
assigned.
ZTR3-ERR-CLIP-PROB (2)
Your management application attempted to add a subdevice but
the operation failed because of an internal CLIP problem.
Check event messages 165 and 164 for CLIP information and
contact your Tandem representative.
ZSPI-TKN-ENDLIST indicates the end of a data list or an error
list. This token is described in "SPI Standard Definitions"
in Section 5 and the Distributed Systems Management (DSM)
Programming Manual .
Operational Notes
ADD is a sensitive command.
When the command is successfully completed, the subdevice is
placed in the STOPPED summary state.
The line must not be in the DIAG summary state when this
command is issued.
6-18
Typically, you can define as
The line must be
Reissue the command
The