HP TR3271 Programming Manual page 169

Bit 10 indicates the subsystem is attempting to connect the
subdevice.
Bit 11 indicates the subsystem is attempting to disconnect
the subdevice.
Bit 12 is not used.
Bit 13 is not used.
Bit 14 is for internal use only.
Bit 15 is for internal use only.
ZLAST-ERR is the last error detected on the queried subdevice.
ZIS-PTP is a Boolean variable that specifies whether the
subdevice is a pass-through protocol (PTP) subdevice.
value of this field can be one of the following:
ZSPI-VAL-TRUE
ZSPI-VAL-FALSE
ZHIS-SYS-NUM is the number of the system on which the TR3271
subdevice resides.
ZHIS-LDEV is the number of the line to which the TR3271
subdevice is subordinate.
subdevices.
ZHIS-SDN is the subdevice number of the TR3271 subdevice.
This field applies only to PTP subdevices.
ZHIS-CU is the controller number of the TR3271 subdevice.
This field applies only to PTP subdevices.
ZHIS-DA is the device address of the TR3271 subdevice.
field applies only to PTP subdevices.
ZSPI-TKN-DATALIST indicates the beginning of a data list.
token is described in "SPI Standard Definitions" in Section
5, "Common Definitions," and the Distributed Systems Management
programming Manual .
ZCOM-TKN-OBJNAME specifies the name of the TR3271 line or
subdevice for which information was requested.
an error that prevents the STATUS command from being attempted at
all, this token is present in every response record.
OBJNAME is described in "Data-Communications Standard
Definitions" in Section 5, "Common Definitions," and the
Communications Management Programming Manual .
This applies to PTP subdevices only.
This applies to PTP subdevices only.
The subdevice is a PTP device.
The subdevice is not a PTP device.
This field applies only to PTP subdevices.
This field applies only to PTP
COMMANDS AND RESPONSES
STATUS Command
The
Unless there is
ZCOM-TKN-
This
This
6-105