Table of Contents
Advertisement
Name
Possible Values
CDP Compatibility
Enabled, Disabled
VLAN ID
Null, 0 through 4094
VLAN Filtering
Enabled, Disabled
Storm Filtering
Enabled, Disabled
LAN Port Mode
0 = Auto
1 = 10HD
2 = 10FD
3 = 100HD
4 = 100FD
5 = 1000FD
PC Port Mode
0 = Auto
1 = 10HD
2 = 10FD
3 = 100HD
4 = 100FD
5 = 1000FD
-1 = Disabled
Note
Ethernet Menu
The following Ethernet configuration parameters can be modified on the
Ethernet menu:
The LAN Port Mode and PC Port Mode parameters are only available on
SoundPoint IP 330, 430, 550, 560, 601, 650, and 670 phones.
Only the SoundPoint IP 560 and 670 supports the LAN Port Mode and PC Port
Mode setting of 1000FD.
Syslog Menu
Syslog is a standard for forwarding log messages in an IP network. The term
"syslog" is often used for both the actual syslog protocol, as well as the
application or library sending syslog messages.
Description
If enabled, the phone will use a CDP compatibility
method. It also reports PoE power usage to the switch.
The default value is Enabled.
Phone's 802.1Q VLAN identifier. The default value is Null.
Note: Null = no VLAN tagging
Filter received Ethernet packets so that the TCP/IP stack
does not process bad data or too much data.
Enable/disable the VLAN filtering state.
The default value is Disabled.
Filter received Ethernet packets so that the TCP/IP stack
does not process bad data or too much data.
Enable/disable the DoS storm prevention state.
The default value is Enabled.
The network speed over the Ethernet.
The default value is Auto.
HD means half duplex and FD means full duplex.
Note: Polycom recommends that you do not change this
setting.
The network speed over the Ethernet.
The default value is Auto.
HD means half duplex and FD means full duplex.
Note: Polycom recommends that you do not change this
setting unless you want to disable the PC port.
Setting up Your System
3 - 11
Advertisement
Table of Contents
