Polycom RMX 2000 Installation & Configuration Manual page 5

Configuring the IP Network Service
The Fast Configuration Wizard enables you to configure the Default IP
Service. It starts automatically if no Default IP Network Service is defined.
This happens during First Time Power-up, before the service has been
defined or if the Default IP Service has been deleted, followed by an RMX
reset.
The IP Management Service tab in the Fast Configuration Wizard is
enabled only if the default Management IP addresses were not
modified.
1
In the Fast Configuration Wizard - IP dialog box, define the following
parameters:
Field
IP Service
Name
Signaling Host
IP Address
MPM 1 IP
Address
MPM 2 IP
Address
Subnet Mask
If Secured Communication is required on the RMX: complete the
Fast Configuration Wizard, Login, install the Certificate and then
enable the Secured Communication Mode.
2
Click Next.
3
In the Fast Configuration Wizard - Routes dialog box, enter the IP
address of the default router.
Description
Use the default name (Default IP Service) or enter a name
using up to 20 characters.
Note: This field is displayed in all dialog boxes.
Enter the IP address of the Central Signaling host. This is
the address used by endpoints for dialing in to the MCU.
Enter the IP addresses of the Media Boards. The
Signaling Host connects endpoints to the Media
Processors via these addresses.
Enter the subnet mask of the MCU.
Default value: 255.255.255.0.
5