Connecting To The Mcu - Polycom RMX 2000 Installation & Configuration Manual

During the First-time Power-up the red ERR LED on the RMX's
front panel remains ON until both the Management and IP
Network Services have been defined.
When the RMX's configuration is completed (including the
Management and IP Network Services), and if there are no System
Errors, the green RDY LED on the CNTL module (on the RMX's
front panel) turns ON.
7
Remove the USB key.

Connecting to the MCU

1
Start the RMX Web Client application on the workstation by
entering in your browser's address line the IP Address of the
control unit as defined in the USB key in the format
<Control Unit IP Address>
2
In the RMX Web Client Welcome Screen, enter the default Username
(POLYCOM) and Password (POLYCOM) and click Login.
The RMX Web Client opens.
The following steps are performed on first entry:
3
The Product Activation dialog box appears with the serial number
filled in.
In the Activation Key field, enter or paste the Product Activation Key
retrieved earlier and click OK.
If you do not have an Activation Key, click the Polycom Resource
Center button to access the Service & Support page of the Polycom
website.
The system prompts with a reset dialog box.
4
In the dialog box, click No.
As no Default IP Network Service is defined, the system
automatically starts the Fast Configuration Wizard.
The Fast Configuration Wizard appears.
4
and pressing Enter.
http://