Installing The Remote Switch - Montigo H36PVN Installation & Maintenance Manual

Step 5.
Route the Power Vent Comunication conduit into the cover
as shown, and connect to the communication Port, Figure 12d .
Power vent
communication
port cover.
Figure 12c. Remove Exterior Access
Cover.
Note orientation of conduit plug into the Port, (flat side / notches).
Step 6. Re-Install the communication harness Port cover, Figure
12e . (Philips head screwdriver required).
Step 7. Tighten Power Vent Strain relief adjustmsent screw, Figure 12e.
Power vent
communication
port cover strain
relief.
Power vent
communication
port cover
fasteners.
Figure 12e. Installing Conduit Port Cover Plate.
XG0649 - 031511
Installation
Note
orientation of
connector
Power vent
communication
harness port
Power vent
communication
harness.
Figure 12d. Locate Power vent
connections.
H36PVN Power Vent Indoor Gas Fireplace

Installing The Remote Switch

The H36PVN's Remote LVT (Low Voltage) Switch conduit is located
on the RH Side of the fireplace .
Note: The switch location must not exceed 30' from the fireplace .
Remote
Switch LVT
Figure 12f. Installing the Remote LVT Switch.
Figure 12g. Electrical Enclosure Dimensions
Page 21