Operation; Section 9: Start-Up Sequence; Honeywell Intermittent Pilot - Montigo H36PVN Installation & Maintenance Manual

H36PVN Power Vent Indoor Gas Fireplace
Section 9: Start-up Sequence
1) Turn the wall switch ON
2) The blowers will start and within 10 seconds the glow plugs will
start to glow
3) If the pilot does not light the gas valves willl turn the glow plugs
off after 20 seconds
Page 28

Operation

XW2008
STARTUP SeqUenCe:
■ This fireplace has been set up at the factory for a
determined air volume though the venting system.
■ This fireplace will not operate unless the correct
air movement is detected by our control system..
■ Please consulted with your contact person at
Montigo should you have any problems with your
start up.
XW2040
WARNING
If the information in these instructions is
not followed exactly, a fire or explosion
may result causing property damage,
personal injury or death.
4) This may need to be done three or four times to bleed all of the
air out of the gas lines within the fireplace
5) Turning the switch OFF and then ON again will reset this start
up sequence
6) Once the pilots are burning the main burner will turn on and
the fireplace will be functional for a quick start up on next use .
CAUTION
XG0649 - 031511