Installation Of The External Roof Mounted Power Vent - Montigo H36PVN Installation & Maintenance Manual

Installing the external roof mounted power vent module
Step 1.
Construct a Vertical Chase for the termination opening to meet
the following requirements:
■ Opening Size must be: 14 1/2" x 14 1/2" x 18" Min . height .
14½"
Figure 5. Construction, Rough-in framing.
Step 2.
Install the Vent pipe female end up, and 2" to 3" MAX . from the
top of the Constructed Chase . Also, at this point install the Electrical
harness, (EPVH-(10-100) that will communicate with the Power
Vent Module .
2" to 3" Max.
Vent Chase
Figure 5a. Installation, Vertical Vent pipe . (female end top end).
XW2024
XG0649 - 031511
Installation
14½"
18"
Electrical Harness
with connection
Vent Pipe
WARNING
All venting material must be sealed with high heat
silicone sealant RV230. All venting material to be
Montigo flex pipe, with as few joints as possible.
All joints use MVA vent splice, sealed thoroughly
with silicone. Montigo will not be held responsible
for any water damage that may occur from not
installing the equipment as specified by this
document.
H36PVN Power Vent Indoor Gas Fireplace
Step 3.
Install the Power Vent Rough-in Kit . Pull wire harness through
the supplied hole in the bottom corner of the rough-in box, and snap
into the slot provided, (See figure 5b inset) .
Electrical Harness
Connerctor Location
Figure 5b. Installation of Rough-in Kit
Step 4.
Install fasteners around perimeter of Rough-in Kit . (Holes supplied
for ease of installation)
Figure 5c. (Fasten Rough-in Kit to framing)
Figure 5d. (Installed Stainless steel cover)
Power Vent
Rough-in Kit
Electrical
Harness
Install Fasteners around
perimeter of Rough-in Kit
Page 11