Whitney (Prismatic) Anamorphic Lens Installation And Adjustment; Prismatic Anamorphic Lens Mounting Assembly - Exploded View - Runco XtremeProjection X-450d Installation & Operation Manual

Installation
Whitney (Prismatic)
Anamorphic Lens
Installation and
Adjustment
The Whitney Anamorphic lens mount kit consists of everything shown in Figure 3-31.
Some components shipped with your projector may differ slightly from what is shown in
these instructions.
6 Anamorphic
Lens
Mounting
Bracket
5 Anamorphic
Lens
Base Plate
4 Swell Latch
Assembly (2x)
Figure 3-31. Prismatic Anamorphic Lens Mounting Assembly - Exploded View
1. Use the Height/Pitch Adjustment Screws (3) and Washers (2) to attach the Lens
Mounting Bracket (6) to the Anamorphic Lens (1).
2. Remove the nut and rubber collar from each Swell Latch Assembly (4).
3. Secure the lens (with the mounting bracket attached) to the Lens Base Plate (5) using
the swell latches.
To avoid clipping the corners of the image, position the anamorphic
Tip
lens as close as possible to the primary lens.
58 Runco X-400d/X-450d Installation/Operation Manual
1 Anamorphic Lens
2 Washer (4x)
3 Height/Pitch
Adjustment
Screw,
4-40 x 1/4" (4x)