Installing The Optional Cinewide Lens Mount - Runco XtremeProjection X-450d Installation & Operation Manual

Installation
3.4
Installing the Optional
CineWide Lens Mount
If you are installing a standard X-400d/X-450d (without an anamorphic lens), skip this step
and proceed with Mounting the X-400d/X-450d (page 32).
If you are installing an X-400d/X-450d/CineWide with a "McKinley"
(cylindrical) anamorphic lens, proceed with Installing the Fixed
CineWide Base Plate (Cylindrical Anamorphic Lens) (page 31).
If you are installing an X-400d/X-450d/CineWide with a "Whitney"
(prismatic) anamorphic lens, proceed with Installing the Fixed
CineWide Base Plate (Prismatic Anamorphic Lens) (page 30).
If you are installing a X-400d/X-450d/CineWide with AutoScope, proceed as follows to
install the AutoScope lens motor.
1. Do not install the CineWide lens yet, only the fixed CineWide
Note
2. Some components shipped with your projector may differ slightly
base plate or AutoScope lens motor. You will install the
CineWide lens after you install the projector and adjust the
primary lens.
from what is shown in these instructions.
26 Runco X-400d/X-450d Installation/Operation Manual