Primary Lens Adjustments: Focus, Zoom And Position; Focus; Zoom; Vertical And Horizontal Lens Shift - Runco XtremeProjection X-450d Installation & Operation Manual

Lens zoom, focus and position are motorized adjustments that are adjustable using the
remote control (Figure 2-6). This allows you to adjust the focus and image size while at the
screen for more accurate results.
To access the motorized lens controls:
1. On the Dimension Digital Controller remote control or front panel, press MENU.
2. Select Service from the Main Menu and enter the Service Menu passcode.
You must enter a passcode to access the Service menu.
Note
3. Select Display Device from the Service Menu.
4. Select Configure from the Display Device menu, then select Lens.
The Lens menu controls operate as described below.
To focus the projected image, use the cursor buttons to highlight "In" or "Out." Then,
press and hold the ENTER button.
To make the picture smaller (zoom out), use the cursor buttons to highlight the minus sign
(-). Then, press and hold the ENTER button.
To enlarge the picture (zoom in), use the cursor buttons to highlight the plus sign (+).
Then, press and hold the ENTER button.
To change the lens position, use the cursor buttons to highlight "Left," "Right," "Up" or
"Down" in the Lens menu. Then, press and hold the ENTER button to shift the lens in that
direction.
To return the lens to its home position (no horizontal or vertical shift), use the cursor
buttons to highlight "Home" in the Lens menu. Then, press the ENTER button.
By default, the X-400d/X-450d is configured for a "floor/front" installation, in which the
projector is installed upright and in front of the screen. If it is installed behind the screen
and/or mounted on a ceiling, you must change the picture orientation. To do this:
1. On the Dimension Digital Controller remote control or front panel, press MENU.
2. Select Service from the Main Menu and enter the Service Menu passcode.
You must enter a passcode to access the Service menu.
Note
3. Select Display Device from the Service Menu.
4. Select Configure from the Display Device menu, then select Installation.
5. Select Orientation, then choose Floor/Rear, Ceiling/Front or Ceiling/Rear, to match
the installation method.
Runco X-400d/X-450d Installation/Operation Manual 49
Installation
3.9
Primary Lens
Adjustments: Focus,
Zoom and Position

Focus

Zoom

Vertical and Horizontal
Lens Shift
3.10
Adjusting the Picture
Orientation