Rear Panel Layout; Dc-300 Dimension Digital Controller Rear Panel - Runco XtremeProjection X-450d Installation & Operation Manual

System Overview

Rear Panel Layout

1
10
Figure 2-5. DC-300 Dimension Digital Controller Rear Panel
Figure 2-5 shows the rear connector panel on the Dimension Digital Controller.
2
3D SYNC
1
Component / SCART Compone ne ent / SCART
Y Y
Pb Pb
DisplayPort
HD2 HD2
11 12 13
1. MAIN POWER SWITCH
Disconnects or applies power to the Dimension Digital Controller.
2. 3D Sync Out
A 3-pin, VESA standard mini-DIN connector for connecting the Runco Active 3D
Emitter to the Dimension Digital Controller (see Figure 3-26).
3. TRIGGERS
Connection for up to three (3), 12-volt trigger-controlled devices such as retractable
screens or screen masks. Output current is limited to 250 milliamperes (mA).
4. USB
A standard, USB Series "B" connection to a personal computer, for performing
software upgrades and other service procedures.
5. RS-232 (To Accessory Box)
Reserved for future use.
6. Pri. Display Control
Connect this to the RS-232 input on the projector.
7. Sec. Display Control
Not used.
8. IR
Wired input from a Niles- or Xantech-compatible, infrared (IR) repeater system. It is a
3.5-mm, mini phono jack, wired as follows:
Ring = No connection
Tip = IR Input
Sleeve = Ground
9. RS-232 (PC / Control)
A female, 9-pin D-sub connector for interfacing with a PC or automation/control
system.
10. POWER INPUT (100 to 240 VAC)
Connect the Dimension Digital Controller to power here.
3 4 5
TRIGGERS
USB RS-232
2 3
To Accessory Box
Video 1 Video 1 Video 2 Video 2
Pr Pr Video 3 Video 3
HDMI 2 HDMI 2 HDMI 4 HDMI 4
14 15
10 Runco X-400d/X-450d Installation/Operation Manual
6 7 8
Pri. Display Control Sec. Display Control
IR
HDMI Out
To Sec. Display
HDMI 6 HDMI 6 HDMI 8 HDMI 8 HDMI Out
Ethernet
Audio Only
16 17
9
RS-232
PC / Control
HDMI Out
To Pri. Display
18 19