Using Hdmi Cec Messages; Cec Command List - Runco XtremeProjection X-450d Installation & Operation Manual

The Dimension Digital Controller accepts and can respond to CEC command messages
from a disc player, satellite receiver or DVR/set-top box via an HDMI connection. Using
CEC, the Dimension Digital Controller can perform the following actions:
• Turn itself and the projector on and select the correct input when the source
component initiates playback of a disc or recorded program.
• Turn the source component on when you switch to its corresponding input on the
Dimension Digital Controller.
• Turn the source component off when the X-400d/X-450d system is turned off (unless
the source component is in playback mode).
• Change its OSD language when a similar change is made at the source.
To use CEC, connect your CEC-compatible sources to the HDMI inputs on the Dimension
Digital Controller. Set the CEC option to On (refer to CEC on page 96). Additional steps
may be needed to enable CEC at the source. Refer to the documentation for your source
device for more information.
Table 6-4 lists the CEC commands supported by the Dimension Digital Controller.
Table 6-4. CEC Commands Supported by the Dimension Digital
Controller
Opcode
Feature Abort
Standby
Routing Change
Routing Information
Active Source
Request Active Source
Device Vendor ID
Give Device Vendor ID
Vendor Command With ID
Polling Message
Text View On
Report Physical Address
Inactive Source
CEC Version
Set OSD Name
Menu Status
Report Power Status
Runco X-400d/X-450d Installation/Operation Manual
Supported? (√ = Yes, – = No)
Value
Initiator
√
0x00
√
0x36
√
0x80
√
0x81
√
0x82
√
0x85
√
0x87
√
0x8C
√
0xA0
√
N/A
√
0x0D
√
0x84
√
0x9D
√
0x9E
√
0x47
√
0x8E
√
0x90
Follower
√
√
√
√
√
√
√
√
√
√
–
–
–
–
–
–
–
127
External Control
6.3
Using HDMI CEC
Messages

CEC Command List