Turning On The Glasses; Auto Power-Off - Runco XtremeProjection X-450d Installation & Operation Manual

Operation

Turning On the Glasses

Auto Power-Off

1. Ensure that the projector is powered on and displaying 3D content.
2. Press and hold the Power Button for about two seconds, then release the button. The
LED will then blink in a pattern that indicates the battery charge state. In general, the
more slowly and less frequently the LED blinks, the more charged (and less in need of
charge) the glasses are. Refer to Table 4-5.
Table 4-5. Battery Charge State Indications
Blink Activity After
Power-on
Three (3) blue blinks (one
second on, one second off)
Six (6) blue blinks
Nine (9) blue blinks
Red blink
3. The glasses will sync with the emitter and the 3D content will be visible through the
glasses.
4. Repeat Step 2 for each pair of glasses you wish to sync to the emitter.
If the glasses do not detect an emitter, the LED blinks on and off once per second for five
minute. Then, to preserve battery life, the glasses automatically turn off. If the emitter is
activated (the emitter is only active when the projector is in 3D mode) before the
five-minute period ends, the glasses stop blinking and remain on.
If the glasses automatically turn off, press the Power button to turn them back on.
Battery Charge State
Battery is fully charged; 12 to 15 hours remaining.
Battery is 50% charged; approximately 4 hours remaining.
Battery is 30% or more charged; approximately 2 hours remaining.
Battery charge is 10% or less; glasses must be charged before
further use.
100 Runco X-400d/X-450d Installation/Operation Manual